Dies ist eine alte Version des Dokuments!

---

opkg install kmod-ipv6

config 'interface' 'loopback'

option 'ifname' 'lo'
option 'proto' 'static'
option 'ipaddr' '127.0.0.1'
option 'netmask' '255.0.0.0'

config 'interface' 'lan'

option 'type' 'bridge'
option 'proto' 'static'
option 'ipaddr' '192.168.1.1'
option 'netmask' '255.255.255.0'
option 'ifname' 'eth0.1'

config 'switch' 'eth0'

option 'name' 'eth0'
option 'reset' '1'
option 'enable_vlan' '1'

config 'switch_vlan' 'eth0_1'

option 'device' 'eth0'
option 'vlan' '1'
option 'ports' '0 1 2 3 5t'

config 'switch_vlan' 'eth0_2'

option 'device' 'eth0'
option 'vlan' '2'
option 'ports' '4 5t'

config 'interface' 'wan'

option 'proto' 'dhcp'

config wifi-device wifi0

option type     atheros
option regdom nz

config wifi-iface

option device	wifi0
option network	wan
option mode	sta
option ssid  	nbsp
option encryption psk2
option key h0lstent0r

#!/bin/sh

gpioctl dirout 1 gpioctl dirout 3

gpioctl clear 1 gpioctl clear 3

while true; do

      gpioctl get 4

      if test $? -eq 1; then
         gpioctl clear 1
         gpioctl set 3
         echo open | nc 2a01:170:1112:0:bad8:12ff:fe66:fa6 6004
         S=$?
         gpioctl clear 3
         if test $S -eq 0; then
           gpioctl set 1
      	   sleep 1
           gpioctl clear 1
         fi
      fi

done